How often to test well water, and what to do after a flood
Last checked November 18, 2026
Official EPA and CDC testing intervals for private wells, when to test immediately, and the steps to take after a well is flooded.
A private well is the well owner’s responsibility. The federal rules that protect public drinking-water systems do not apply to most private wells, and officials do not routinely test or treat that water for you.[1][2] Testing on a schedule — and again after a flood or other change — is how you find out whether the water is still safe to drink.
This page summarizes official guidance we fetched on November 18, 2026. If a source page later changes, follow the official page. This is not medical advice.
The annual tests EPA and CDC both recommend
CDC and EPA both say to test a private well at least once every year for:[1][2]
- Total coliform bacteria
- Nitrates
- Total dissolved solids
- pH
CDC also says to ask your health department what other germs or chemicals to test for based on where you live, and to use a state-certified laboratory.[1] EPA adds that if you suspect other contaminants, you should test for those as well, and that your local health department can tell you what is common in the area’s groundwater.[2]
CDC recommends checking the well itself every spring for mechanical problems, in addition to the annual water test.[1] EPA’s older Home Water Testing fact sheet, still linked from EPA’s current home-testing page, also says to test every year for those same four items, especially if you have a new well or have replaced or repaired pipes, pumps, or the well casing.[3]
Nitrate deserves special attention. CDC says high nitrate levels can make people sick, especially babies, and can come from fertilizer, septic systems, animal waste, flooded sewers, and storm runoff. If nitrate is high, other harmful chemicals or germs might also be in the water.[1] EPA’s fact sheet says to test for nitrate in the early months of a pregnancy, before bringing an infant home, and again during the first six months of the baby’s life, and that spring or summer after a rainy period is a useful time to test for nitrate.[3]
When to test immediately, not just on the annual date
You should also have the well tested, even if the annual test is not due, if:[1][2]
- You are notified of well-water or groundwater problems in your area
- Conditions near the well have changed — flooding, land disturbance, new construction or industrial activity, or nearby waste-disposal sites
- You replace or repair any part of the well system
- You notice a change in the water’s taste, color, or smell
- You or someone in the household becomes pregnant, or a child starts living with you (CDC)
- Small children, elderly adults, or someone who is pregnant or nursing lives in the house, and you are considering testing more often (EPA)
EPA also publishes a condition-based list of extra tests — for example lead and pH if plumbing may contain lead, pesticides and nitrate near intensive agriculture, or volatile organic compounds if you smell gasoline or live near tanks, dumps, or dry cleaners. Use that list with your health department rather than guessing.[2]
After a flood
Floodwater can carry contaminants into a well through a loose cap, a damaged casing, or the ground itself. EPA says to treat a flooded well as unsafe until it has been inspected, cleaned, disinfected, and tested. Its flood-response steps are:[2][4]
- Stay away from the well pump while it is flooded to avoid electric shock. Do not turn the pump on until a qualified electrician, well contractor, or pump contractor has checked the wiring. Wet or submerged electrical components are a shock hazard; rubber boots and gloves are not adequate protection.
- Do not drink or wash with water from a flooded well.
- Get a well or pump contractor to inspect, clean, and disinfect the well before the pump is turned back on. EPA’s after-the-flood publication says drilled, driven, or bored wells are best disinfected by a contractor because it is difficult for a private owner to disinfect them thoroughly. CDC likewise says work on a well after a disaster can be hazardous and should be done by a well or pump contractor, after you check with local authorities.[5]
- After the pump is back on, pump the well until the water runs clear to purge floodwater. If it does not run clear, get advice from the county or state health department or extension service.[2]
Official pages also warn that boiling or chlorination will not make water safe if it is contaminated with fuel, pesticides, or other chemicals. If the water smells like fuel or chemicals, or you are in an area where a chemical release is likely, contact the health department and use bottled water until you know the water is safe.[5][4] CDC’s emergency guidance is to drink bottled water until you are certain the water is free of contaminants.[5]
EPA’s after-the-flood publication, updated October 2024, also cautions that a well may not be a safe source for many months after a flood. Wastewater from a damaged septic system or chemicals in the ground can contaminate groundwater even after one test comes back acceptable, so repeated testing is part of the long-term response. Septic systems should not be used immediately after floods, because drain fields will not work until underground water has receded, and lines may have broken.[4]
Testing after disinfection
Do not treat a freshly chlorinated well as cleared until laboratory testing says so. CDC says to wait at least 7 to 10 days after disinfection, and to flush until chlorine is gone, before sampling. Until the water has been tested, boil it (a rolling boil for 1 minute) before use, or use another safe source. Sample for total coliform and either E. coli or fecal coliform. If those bacteria are absent, CDC says the water can be considered safe to drink, and then to follow up with another test in 2 to 4 weeks and another in 3 to 4 months. If bacteria are still present, repeat disinfection and test again; if they persist, contact the local health department.[5] EPA’s after-the-flood publication likewise says to have the water tested for bacteria 7 to 10 days after disinfection, and to use a certified laboratory or the local health department.[4]
When to call a professional
Call your local or state health department for sampling bottles, a list of certified laboratories, and advice after a flood or a bad test.[1][4]
Call a qualified electrician, well contractor, or pump contractor before restoring power to a flooded well, and to inspect, clean, and disinfect the well. Do not enter a well pit; gases can build up there.[5][4]
This guide is a reading of official pages, not personal medical advice. If someone in the household is ill, pregnant, or nursing, or if an infant drinks the water, contact your clinician and your local public health agency.
Sources
All of the following were fetched on November 18, 2026 (checked Nov 18, 2026).
- CDC, Guidelines for Testing Well Water — checked Nov 18, 2026
- EPA, Protect Your Home’s Water — checked Nov 18, 2026
- EPA, Home Water Testing Facts (EPA 816-F-05-013, May 2005; still linked from EPA’s Home Drinking Water Testing page) — checked Nov 18, 2026
- EPA, What to Do After the Flood (EPA 816-F-05-021, August 2005, updated October 2024), linked from EPA, What to Do With Your Private Well After a Flood — checked Nov 18, 2026
- CDC, How to Disinfect Wells After an Emergency — checked Nov 18, 2026